Wine Sheer Curtains

Wine Sheer Curtains | Window treatments can definitely change an area by having stunning impact and highlighting the views through the window.Sometimes one of the most dramatic window treatments require installing various types of decorative drapery hardware, this also hardware must be installed correctly and uniformly to make sure that window treatments look superb.

Most window fashions focus on setting up a curtain-rod, the basis for supporting the valence, curtain, sheer, or drapery. When installing a curtain rod, it’s always best to choose how far out through the window frame you would like the rod to stick out, and after that to screw inside the curtain rod mounts inside the closest studs to the window frame. You can use a stud finder, or depend upon tapping the wallboard until no sound hollow, to find the stud. Next make sure that the mount is defined it to be high enough that the curtains covers the top from the window. Placing the mount higher than the top from the window by a few inches usually looks better. Hold the begin and rehearse a pencil to mark the location of the bottom screw hole. Then drill an opening to the wall to the screw. Hold the mount backup and ultizing the drill, put the screw inside the bottom from the mount. Level it, and screw inside the top screw.

See also: Double Curtain Rods Ikea

Next put the finials on the end from the curtain rod if it is not already attached. Put the curtain-rod into one end from the mount, walk to the opposite side from the window with the other mount along with the curtain-rod inside your hand. Hold the begin with the curtain rod in it, and ultizing an amount throughout the top from the rod, boost the mount until it can be level with the opposite side. Mark the mount bottom screw hole, and inside the same manner as before, screw inside the mount.

Remove the curtain rod through the mount. Unscrew one finial and either slide on curtain rings or perhaps the curtain panel. Attach the curtain to the rings if applicable, and place the curtain rod inside the mounts. Measure up through the window frame and out through the window frame a similar distance as the first curtain you set in order that all subsequent mounts are equidistant plus your curtains look uniform.